Search results

None that i know of, you can use additives to maintain but they never actually clean all of the soot out, you unfortinatly have to remove it and either clean it out or replace it and delete the emmisions systems to avoid it ever happening agan

Thank you for the info, is there any way to de soot the intake if i take it off?

Clean the MAP sensor its probably pluged with soot

I have a 2019 ED that recently hit 164,000km on the odometer and last week in ontraio it was pretty cold (-35c) I started my truck to warm up every thing was fine until i got on the highway, then of courice the dreaded "service electronic throttle control" light came on and it wen into limp...

Well i can tell you the SLT has the plug by the hood latch but terminates under the fuse pannel that is under the hood, had to add a pin to plug A, pin 11 on the BCM and solder the resistor to the wire then grounded the resostor and it worked, so basically the SLT is not eqqupied but can be...

Keep in mind it might not be connected to the bcm

Sorry this plug is at the top left if the BCM

Well i fugured it out, and it works great, if any one is looking for the plug and the pin out for connector a pin 11 here it is, this plug is pocated at the top right corner of the BCM, simply put a wire and a female pin in the BCM plug and solder an inline resitor (1000ohm 1w 5amp) to the wire...

I did this to my truck last night but it appears that the hood latch sensor wire harnes is not pluged into the BCM i know this because it says remot start cancled hood open but i have the resistor in and every thing done right on alfa so now i need to figure out how to connet that harnes to the...

J DIY Articles Hood latch wireing harnes not conected at BCM Thread starterJust-a-guy Start date10 minutes ago TagsNone Unwatch ••• J Just-a-guy New Member 10 minutes ago Add bookmark #1 Hey every one, I have a 2019 ed 1500 slt I have recently discovered how to enable remote start and...

Id drop the oil anyways and get fresh just to be safe, alot cheaper a new engine.. Just my honest opinion tho

Hey every one, I have a 2019 ed 1500 slt I have recently discovered how to enable remote start and ran into a bit of a snagg... The hood latch wireing harnes dosn't seem to be connected to the body control module. My question is has any one sucessfully connected it at the BCM? If so what pin...

Yeah ive come to the same conclusion

You are lucky you have the back up. id be asking for a loaner for sure

Id be loosing my mind as my truck is my daily driver...that is unexceptable they should be making parts for the product they are selling before they sell the product, if this happens to me i can guarantee id sell the truck and get a HEMI

No he was towing his 5th wheel camper trailer up his street witch is a pretty steep hill and did not have the tow/haul button on causing the truck to think it was getting low boost due to going up hill with the heavey load, basically the truck didn't know it was towing and flaged a low boost...

Hello, I'm Curious if anyone can tell me what size resistor to put into the hood latch wire socket in order to enable the remote Start Feature using AlfaOBD, I watched a video of a guy doing it, but he won't disclose what size resistor to put in the hood latch sensor socket and wont answer any...

Yes it has bin re flashed, and it still runs it just went into limp mode right away, truns out i was a low boost pressure code, i cleared the code and the truck ran like normal, I ran the truck hard and it never came back yet, could have just bin some dirt or a fluke

My dad has a 2016 ED and recently towed his 5th wheel trailer about 50 kms and the service electronic throttle control came on and the truck went into limp mode, any ideas what could have caused this issue?