Search results

Hey folks, Sorry I haven’t been as active I started a new job and don’t get good signal! So I know to replace the turbo it’s recommended the cab come off, but any members out there cleaned one? Did a job in jersey and I pulled my trailer up and back. Fully deleted with 159k. Was running 75-80...

Correct. This is the one I use just fine and paid 50 for software.

Get a code reader and clear the codes that way

Honestly you may do better buying a new one lol I’ve heard they aren’t fun

welcome!

Welcome, unless you plan to do 100% interstate driving, the egr will continue to cause issues. The way i see it is, by removing a part and slightly increasing emissions, I’m keeping my truck from burning to the ground, and out of a scrap yard with more impact to the environment than a few...

Welcome! Go into your radio, then settings, then trailer settings and you will be able to adjust what type of trailer, what type of brakes, and so on!

Check out sofaking tune, they have just the trans tunes availiable

I use mine in the dash for my phone charger, charging drill batteries ect. It’s 115w at max I think.

Your battery could be getting weak

Welcome, did it throw any codes? 10k sounds like high pressure fuel pump and injectors failed

The difference is, one has a handheld you can swap between stock and tuned, the other requires the physical ecm to be replaced to tune.

The in tank pump or hpfp

I did the rough country 2” leveling kit. I had to modify the frame washer on the kit for the bump stop by cutting part of its tab off before I installed it. I did not have to modify my frame.

Welcome! I had an issue with my wiring harness to the roof antenna after the top of my cab had issues. Alfaobd and a Bluetooth obd adapter will allow you to check codes as the dealer would and possibly repair or reset it. It’s around 100$ for the setup

Welcome! Most likely it wiped out the injectors If it went. How did they reach the diagnosis?

Just a shot in the dark, it could be the lift pump but I would assume that would throw a code for low fuel pressure. Unless the hpfp is the one detecting pressure. Either way I would Check over all your fuses then grounds. Normally the tone ring throws a code when it destroys the sensor. I read...

Possibly remove the battery cables for a few minutes or try this procedure compliments of another forum member John who posted this. But if you plan to keep the truck for a while, it would be a wise investment (around $100) to have the software and connector. Once you replace the part, a simple...

I don’t see why it should require a dealer trip or calibration. If you have a laptop or android device, look into alfaobd and a obd Bluetooth adapter, it will allow you to do most everything the dealer can do.

Honestly if it has had repetitive issues, I would consider looking at different vehicles or consider an off road tune to eliminate most of the common issues of these trucks. 25-27k trade in sounds like Id be selling mine 🤣