- Thread starter
- #21
My 2015 eco diesel had 36,000/100,000 mile 5 yr. drive train warranty from FCA, I would think yours has one too, even if your a second owner, I would sure as hell ask. (I bought my pickup new). As an example, I developed a slight rear oil seal crankshaft leak at at 99,000 miles and they fixed it no questions asked. I was out of warranty at 121,000 miles when mine quit and had to pay for it, as I recall the tone ring was about $150.00, the sensor $460.00, transmission removal and install $880.00 for a total of around 1,500.00 with tax etc. I had the dealer do it with FCA parts, so the cost was retail plus 10% if you understand my meaning. The Ring and the Sensor are forward of the flywheel and can be replaced, with the transmission and flywheel removed, in about 15 minutes, and then you go back together. I had a handheld Autel AL329 ob2 reader that gave me the code that said that it was a crankshaft sensor. (Napa can probably read it, if you don't have a newer reader of your own.) My local FCA dealer wasn't so sure it was the sensor until they took it out, they thought it was just the tone ring at first, which it was, they told me that they seldom replaced the Sensor, just the tone Ring and carried it in their parts dept., they had to order the sensor. 2 little pieces of the laminated tone ring tape came off and hit the sensor and damaged it enough, that they replaced the sensor. If you do it at a none dealer shop, Napa has the same Sensor for about $97.00, (just use a pn# cross to find it.)the tone ring, you have to buy from FCA. My tone rings outside magnetic tape looked like it was heat checked and was missing pieces of tape.
My thoughts with you losing the tone ring at 67,000 miles and mine at 121,000 (both pickups being 2015's) it sounds like its not mileage but a time/heat issue causing the failure. (if that is what your problem is?) Good luck.
My thoughts with you losing the tone ring at 67,000 miles and mine at 121,000 (both pickups being 2015's) it sounds like its not mileage but a time/heat issue causing the failure. (if that is what your problem is?) Good luck.