It's a pretty tight fit inside the headlight housing I think to do an led high or low lamp you would need to use the ribbon style or you will basically have to run without the entire dust cover on back because of the size hole you would need drilled for the fan and heat sink style. I run a high end hid kit from Enlight automotive in my low beams and it is absolutely fantastic. Low beam lights stay on and adjust up as well as the high beam turning on which is still the halogen lamp. This is a good combo because the yellow of the halogen actually provides more visibility to the human eyeHas anyone replaced their headlights with leds? I have a 2016 Laramie. I have read that the cam system will not work with led headlights. I have a shop that will install them and if the don't work will remove them for free. Any thoughts?
Definitely try out the enlight system for your low beams, it's awesome. Don't even use my fogs anymore and the factory halogen high works great. So it's cheaper than 3x cheap led systems!I realize that this thread is a bit old... but I wanted to weigh in with my experience with LED with my 2016 Laramie with Projector style lights. I've been running with the OPT7 LED lights (cost from Amazon @ $100.00 US) and I've not been happy. The light is not very bright at all. I'm running these in my fog lights too and hight beams which are of course reflective and they work good. I'm thinking the LED's are not really designed for the Projector style light housing(s). So, it seems I'll be needing to get an HID conversion as mentioned here. Just wanted to share my experience.