Engine fails me again. No errors just got in, turned the key and just gave then slow groan of "you left something on" kind of last breath. So I charged the battery, all dash light on but will not turn over.
I am new to the group. I have a 2020, leaking fuel out of one of the wire connectors on top of fuel filter. I would appear I will have to order a new filter body. Are there any aftermarket parts out there? Also what is the procedure for releasing the fuel line clips and wire harness clips, no doubt it is easy if you know how they work. Thanks for any input
What is the measured voltage on pin 11? Is this right at the connector? The code description states it can be from a high or low voltage. Does the engine start and run? As there is another pin that sends power to the auto stop relay. Only other thing I can think of would be the CAN bus circuit. With luck this info is to late and you have already gotten it fixed.
Wayne
hey so how did you fix your P0428 error? was it the temp sensor? or O2 sensor?
I am having the exact same issue. parked regen stops due to catalyst temp sesor reading too high. runs steady around 600c then instanly bolts to 999 and stops regen
2018 Ram Ecodiesel 54,000 miles, engine blew up. Ram put in new engine gave 2 year warranty. 3.5 years and 73,000 more miles. The truck shut down, no notice, Low Oil Pressure. I checked the oil it was fine. I started the truck up, drove 1 mile, it quit again, said Electronic Throttle Control.
I'm new here, I have a 2017 eco diesel with 91k on it. I ran it out of fuel and after putting 2 gallons in followed online instruction to prime and start. I got it to start, but dies anywhere from 10 seconds to 2.5 minutes and then have to reprime and start again. Could the fuel filter be overwhelmed since I ran out of fuel or possibly the injector pump or fuel pump failing? Waiting for a tow truck now. Ugh!
2014 Ram ecodiesel 220k kms. In southern Ontario, Canada. Ok on maintenance issues but have been reading a lot about stage 1 and 2 and full deletes. All is foreign to me mechanically challenged. I would need to take it to someone to do it. Main question is , Is it legal and anyone in Southern Ontario know where to get it done and approximate costs. TIA.