I did the rough country 2” leveling kit. I had to modify the frame washer on the kit for the bump stop by cutting part of its tab off before I installed it. I did not have to modify my frame.
Welcome! I had an issue with my wiring harness to the roof antenna after the top of my cab had issues. Alfaobd and a Bluetooth obd adapter will allow you to check codes as the dealer would and possibly repair or reset it. It’s around 100$ for the setup
Just a shot in the dark, it could be the lift pump but I would assume that would throw a code for low fuel pressure. Unless the hpfp is the one detecting pressure. Either way I would Check over all your fuses then grounds. Normally the tone ring throws a code when it destroys the sensor. I read...
Possibly remove the battery cables for a few minutes or try this procedure compliments of another forum member John who posted this. But if you plan to keep the truck for a while, it would be a wise investment (around $100) to have the software and connector. Once you replace the part, a simple...
I don’t see why it should require a dealer trip or calibration. If you have a laptop or android device, look into alfaobd and a obd Bluetooth adapter, it will allow you to do most everything the dealer can do.
Honestly if it has had repetitive issues, I would consider looking at different vehicles or consider an off road tune to eliminate most of the common issues of these trucks. 25-27k trade in sounds like Id be selling mine 🤣
Sounds like your tank pump is going out on thermal limit when it gets that low. Tcdiesel explained it on a previous thread but long story short, the return fuel line dumps directly onto the pump when the tank is low. In Florida where it is warm to start with, the fuel in the tank will heat up...
I want to say yes, but if you ever take your truck to the dealer, you will want to put your factory ecu back so you don’t lose your tune or changed settings that were made in alfaobd
It will need the vin changed, and injectors recoded, if I recall correctly. Alfaobd offers the option to do what is needed for around 75-100$ depending on what obd connector you choose.